Roche ACCU-CHEK Inform II Manual del operador descargar pdf (Pagina 97)

Initial Startup

5 Place the tapering end of the battery pack on the

small ledge of the opening and push down like a lid

to close (as shown in the illustration below). Make

sure that the plug connector wires slide into the

groove provided for them on the battery pack.

Gently pushing down the “lid” as described here

helps to align the wires properly so that they do not

get pinched or bent.

6 The battery pack should now fit neatly inside the

meter. If this is not the case, check whether the

screws have been loosened enough or if the wires

are caught between the sides of the battery pack

and the meter.

7 Tighten both screws until snug (do not

overtighten). Until then, the cover will have some

play due to the inner gasket and the o-rings around

the screws. After you have tightened the screws,

the cover should be flush with the sides of the

meter.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 159 160

Sin comentarios

Roche ACCU-CHEK Inform II Manual del operador Pagina 97